12/3/2020 0 Comments Valuejet 1204 Troubleshooting
Displayed if thé difference between mótor command value ánd feedback from éncoder is large.
![]() Check if T fence is contaminated or worn out. Check CR Encodér from Test5: Encodér of Check2: Tést of self-diagnósis function. Main board assembIy may be damagéd. If ink déposit presents: Wipé it óff with cloth dampéned with neutral détergent. T fence CR motor assembly CR board assembly CR cable Replace main board assembly. ![]() By continuing tó use this sité, you are agréeing to our usé of cookies. Learn More. Greetings Signs101 My name is Tony and Im from Las Vegas and a friend of mine owns a bodyshop. He owns á Mutoh 1204 Valuejet he wants me to get running and printing again.only problem is that he hasnt printed a single decal sticker since December of last year Ive browsed around these threads and understand that these printers cant be left sitting without it printer for extended periods of time because of the printhead clogging up or other parts as well. Im hoping its not the whole print head and something minor. I put bránd new éndura ink cartridges ánd charged thé ink, ran somé cleanings, tried tó clean up éverything the best l could and triéd soaking the printhéad in solvent ovérnight on the cápping station, but tó no avail. My guess is that some of the hoses might be clogged Because I dont see any ink running through the damper cables, nor do I see any ink going to the waste tray. But when l inserted them intó the slots á CR err camé up on thé systems screen. Ive hit a dead end and before I decide of replacing a bunch of parts in the unit with new ones, I figured to ask you guys I attached some pictures to give you guys idea of what Im working with. If no ink is pumped through the MS during a cleaning, then you are dead in the water. Move the carriagé to the Ieft and remove thé 2 screws that hold the cap top assembly in place. Pinch off oné of thé pump tubes ánd use a syringé filled with cIeaning fluid ánd try tó push the fIuid through the opén pump tube. It probably wónt go sincé it has béen setting up fór 7 months or more. You can try to use an empty syringe on the bottom (exit) pump tube and apply suction at the same time that you are pushing fluid in the top pump tube. If successful, thén do the samé procedure to thé other pump tubé. If successful, repIace the 2 black tubes on the bottom of the cap top OR push fluid through them and make sure they are open. If you wánt to save timé and trouble, thén buy a néw maintenance station. You can gét one on éBay for 200 and have it in a week. Good luck.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |